Bathroom Tile Installation
A bathroom is one of the most water-exposed spaces in a home, and the tile work there has to do more than look good. It has to keep water where it belongs. That means the waterproofing layer comes before everything else.
We install tile on shower walls, tub surrounds, shower floors, bathroom floors, and niches. Waterproofing membrane application is part of every shower and wet wall job we take on, not an optional add-on.
(916) 282-7977
Why Waterproofing Matters Here
Cement board (the typical substrate behind bathroom tile) is water-resistant, but it is not waterproof. Without a membrane over it, water vapor and liquid water that get past the grout lines will eventually saturate the substrate and reach the framing behind it. By the time that damage is visible, it is usually extensive.
We apply a sheet-applied or liquid-applied waterproofing membrane over the substrate before any tile goes up. The membrane covers the entire wet area, with extra attention to corners, seams, and penetrations (where pipes come through). We then embed the tile into an appropriate thinset over the membrane. This sequence adds time to the job, but it is what makes the installation last.
Shower floors get a different approach from walls. A shower floor needs to slope toward the drain, typically a quarter-inch per linear foot. We mud the floor to establish that slope before the tile goes down. This is called a mud bed or shower pan, and it is the correct way to do it when the tile is going over a waterproofed surface.
What We Install
Bathroom Work
Planning a bathroom remodel? Start with a call to (916) 282-7977 or submit your project details online.